Monday 22/7/2019

Bookmark and Share
 
 
Case Studies
  PandCT RSS Case Studies feed
HBM technology takes the load during bridge project

8 July 2019

Measurement specialist’s equipment helps ensure success of Hercílio Luz bridge restoration

As part of a major project to restore Brazil’s longest suspension bridge, construction company Teixeira Duarte used optical and strain gauge technology, provided by HBM, to ensure the 90-year-old structure would provide safe passage for numerous pedestrians and vehicles crossing each day.

Opened in 1926 to link the Island of Santa Catarina to mainland Brazil, the Hercílio Luz bridge maintained its original structure despite sea corrosion and ever-increasing vehicle weight - loads much higher than it was originally designed to bear. Safety fears meant Hercílio Luz was completely closed in 1991, but it has since been declared a historical landmark and plans to restore the bridge put in place.

Teixeira Duarte was hired for the complete rehabilitation of the Bridge, including replacement of bearing supports in the main towers, reinforcement and recovery of foundations, plus application of new decks for vehicles and pedestrians.

The most critical part of the project involved the transfer of load from the central span of the bridge to auxiliary structures. To overcome this challenging step, Teixeira Duarte chose HBM’s technology, including sensors and optical interrogators with Fiber Bragg Grating (FBG) technology to monitor strain at critical points in the structure, electrical sensors for reading of various signals including inclination, temperature, wind and sea current.

Ricardo Martins, Teixeira Duarte’ Project Engineer explained: “The more technically complex activity is the load transfer procedure which consists of the tension relief on the eye-bars allowing their sequential replacement. The execution of this procedure implied the instrumentation of several points of the original and provisional metallic structure, with strain sensors and the application of other electric sensors as inclinometers - and climatic sensors making the total of 312 sensors. HBM presented the best offer of supply and installation, achieved through the optimized use of combined technologies; optical technology for strain measurements and data transmission to the control center, electrical for other measurements and a timely installation methodology that was required by the physical schedule of the work.”

For more information, please contact:

Heather Wilkins
Marketing Coordinator
Bruel & Kjaer
Tel:  01223 389 800
Email: heather.wilkins@bksv.com
Web:  www.bksv.com
PandCT.com are not responsible for the content of submitted or externally produced articles and images.
Click here to email PandCT about any errors or omissions contained within this article.
     
Send this page
To send this page to a colleague or friend,
fill in the email addresses below...
Your email address
Their email address:
Page to be sent: shownews.asp?ID=53857

Company gateway pages
for HBM United Kingdom Ltd:
FREE Information on the products in this article
To request more information from this supplier,
fill in your email address below.
Your email address
 
     
Bookmark and Share
Product categories: Accelerometers | Actuators | Agitators | Analysers | Bearings | Compressors | Controllers | Conveyors | Drives | Enclosures | Flowmeters | Heat Exchangers | Motors | Pumps | Relays | Sensors | Transducers | Transmitters | Valves | Weighing
(c) Copyright 1999-2019 Process and Control Today Ltd  |  Reg. no 3733110  |  Email Editor  |  Email Webmaster  |  Sitemap  |  Privacy Policy