Tuesday 23/1/2018

Bookmark and Share
 
 
Product Focus
  PandCT RSS Product Focus feed
Level Solutions for Feedwater Heaters

10 January 2018

Optimizing feedwater heater level control is an effective way to easily improve power plant efficiency and reduce fuel costs. Feedwater heaters use extraction steam from the turbine to raise the temperature of water destined for the boiler. Water first passes through low-pressure heaters and into the deaerator where excess oxygen is removed. The feedwater then passes into the high-pressure heaters where it is further heated and pressurized. The primary benefit of this process is that the feedwater heater decreases the fuel costs by using recovered energy – rather than costly hot gas – to heat the water.

Feedwater heater level measurement in the field

The key to efficient operation of a feedwater heater is to optimize the condensing zone in an effort to transfer as much of the available energy as possible to the boiler feedwater while maintaining sufficient cooling of the tubes to prevent premature damage of the hardware due to thermal overload – all of which are an inherent part of the feedwater heater design.

Level Measurement Challenges and Considerations

Feedwater heater level is controlled to (1) prevent level from rising into the extraction line; (2) keep the tube surfaces in the condensing zone immersed; and (3) keep the drain cooler flooded. The effectiveness of a shell and tube heat exchanger in transferring energy is contingent, barring hardware anomalies, on accurate level control.

According to ASME standards, two separate level control loops should manage each feedwater heater. Level instrumentation must also be able to withstand moderate to high temperatures and pressures and turbulent conditions. Many level instruments are unable to adjust to turbulence or change in pressure and thus provide inaccurate readings in feedwater heater applications.

Level Measurement Solutions

Magnetrol® produces several instrumentation options to address the level measurement challenges of monitoring feedwater heaters:

For point level:

Model B40 float-actuated or Series 3 external cage switches
For continuous level:

Eclipse® Model 706 guided wave radar transmitter with 7YS steam probe or E3 Modulevel® displacer transmitter

For visual indication:

Atlas™ or Aurora® magnetic level indicators can be supplied with switches or transmitters

More Information

For more information on level solutions for feedwater heaters and other power generation applications, download the power industry brochure. You can also download the steam generation applications brochure for more information on level solutions for the steam generation and condensate recovery process.

For more information, please contact:

Magnetrol International
705 Enterprise St
Aurora
IL 60504-8149
USA
Tel:  +1 630 969 4000 
Email: info@magnetrol.com
Web:  www.magnetrol.com
PandCT.com are not responsible for the content of submitted or externally produced articles and images.
Click here to email PandCT about any errors or omissions contained within this article.
     
Send this page
To send this page to a colleague or friend,
fill in the email addresses below...
Your email address
Their email address:
Page to be sent: shownews.asp?ID=50244

Company gateway pages
for Magnetrol International UK:
FREE Information on the products in this article
To request more information from this supplier,
fill in your email address below.
Your email address
 
     
Bookmark and Share
Product categories: Accelerometers | Actuators | Agitators | Analysers | Bearings | Compressors | Controllers | Conveyors | Drives | Enclosures | Flowmeters | Heat Exchangers | Motors | Pumps | Relays | Sensors | Transducers | Transmitters | Valves | Weighing
(c) Copyright 1999-2018 Process and Control Today Ltd  |  Reg. no 3733110  |  Email Editor  |  Email Webmaster  |  Sitemap  |  Privacy Policy