Monday 21/8/2017

Bookmark and Share
 
 
Case Studies
  PandCT RSS Case Studies feed
Hydra-Cell the Pump for De-scaling

31 July 2017

When a major producer of heavy-duty industrial cleaning machines and jet washers was commissioned to design and manufacture a high-pressure cleaner/de-scaler for an agricultural equipment manufacturer, they turned immediately to Hydra-Cell Seal-less pumps from Wanner International.

The biggest pumping problem with such heat treatment de-scaling installations is the solid scale particles that invariably bypass filtration stages to some extent in such re-circulating, closed loop systems. Such abrasive particles cause severe damage to pumps that rely on close internal tolerances for efficiency. Seal wear, caused by the finest particles can be expensive and at worst catastrophic for these types of pumps. 

Hydra-Cell diaphragm pumps have no dynamic seals to wear and no tight internal tolerances, ensuring long-term efficiency and reliability with no seal maintenance.

The Company had good past experience of using Hydra-Cell leak-free, low maintenance pumps but for this particular application the liquid flow requirements were substantially higher than previously encountered.

The answer was to use four Hydra-Cell T100K triplex pumps in parallel in order to achieve a flow of 681 lpm at 193 bar pressure. The pumps handle the solid abrasive particles with ease and have proved to be an exceptionally reliable solution.

For more information, please contact:

Nick Herrington
Wanner International
Tel:  +44 (0)1252 816847
Email: NHerrington@wannerint.com
Web:  www.hydra-cell.eu
PandCT.com are not responsible for the content of submitted or externally produced articles and images.
Click here to email PandCT about any errors or omissions contained within this article.
     
Send this page
To send this page to a colleague or friend,
fill in the email addresses below...
Your email address
Their email address:
Page to be sent: shownews.asp?ID=49145

Company gateway pages
for Wanner International Ltd:
FREE Information on the products in this article
To request more information from this supplier,
fill in your email address below.
Your email address
 
     
Bookmark and Share
Product categories: Accelerometers | Actuators | Agitators | Analysers | Bearings | Compressors | Controllers | Conveyors | Drives | Enclosures | Flowmeters | Heat Exchangers | Motors | Pumps | Relays | Sensors | Transducers | Transmitters | Valves | Weighing
(c) Copyright 1999-2017 Process and Control Today Ltd  |  Reg. no 3733110  |  Email Editor  |  Email Webmaster  |  Sitemap  |  Privacy Policy